my car 3008 - 2016
for some reason i take off a start engine fuse when i close it
at morning when i reconnect that fuse and connect battery , it working but shows more error in screen at once
engine fault \ gearbox fault\ esp/asr fault \ power steering fault
i take all souluttions.. cheks fuses - replace battery - but still error - can move but without power steering and still showing error masseges
this is report for error code form a obd11 device
pls help till me how i found the reason
3008-2016 - multiple error at once pls help
u1308 fault in the gearbox electrical control on the can network . incorrec value recived
u1213 can network . fault in comunication with the abs/esp ECU
U1313 Absence on comunication with the esp ECU. NOTcharacterised
u1108 fault absence of comunication with the engine management ECU and the hybrid management ECU (if the hubrid management ECU is present) no signal
u1213 absence of comunication with the esp/ECU . Incorrect value received
engine ecu
u1213 can network .fault in comunication with the abs/esp ECU
u1109 can network .comunication fault with the gearbox ecu
c1320 front lh wheel speed sensor signal fault .short circuit to posittive or short circuit to earth or open circuit
u1325 no comunication with gyroscope accelerometer sensor . no signal
p1385 super-knock information . detection on injection cut-off
p2336 super-knockdetection . injector cylender no.1
u1213 can network . fault in comunication with the abs/esp ECU
U1313 Absence on comunication with the esp ECU. NOTcharacterised
u1108 fault absence of comunication with the engine management ECU and the hybrid management ECU (if the hubrid management ECU is present) no signal
u1213 absence of comunication with the esp/ECU . Incorrect value received
engine ecu
u1213 can network .fault in comunication with the abs/esp ECU
u1109 can network .comunication fault with the gearbox ecu
c1320 front lh wheel speed sensor signal fault .short circuit to posittive or short circuit to earth or open circuit
u1325 no comunication with gyroscope accelerometer sensor . no signal
p1385 super-knock information . detection on injection cut-off
p2336 super-knockdetection . injector cylender no.1
Hi, I had a very similar problem with my 2016 3008. I had multiple problems flashing all at once, then it would sort itself out. Then start all over again. The problem was detected as some loose wiring going into/out of the fuse box/boxes. These were sorted out and I've had no problems since. Good luck!